Everdrive-MD Flash Cart

[evildragon]

Just ordered the last one from tototek.

Can't wait to use this thing!

[aka DaBigKahuna]

Hi, I'm sure this is embedded somewhere in the 60 pages, but I looked briefly and could not find it.

How is the gameplay vs. actual carts?
How is the graphics vs. actual carts?

[Joe Redifer]

Identical.
Identical.

[synapse]

Once you put the rom inside, you are playing with an actual cart.

[makinagenesis]

Hi, I'm sure this is embedded somewhere in the 60 pages, but I looked briefly and could not find it.

How is the gameplay vs. actual carts?
How is the graphics vs. actual carts?

seriously made me laugh

[NeoVamp]

How is the graphics vs. actual carts?

Its horrible, everything is Atari 2600 style ;_;

[Chilly Willy]

Its horrible, everything is Atari 2600 style ;_;

And if you accidentally write the rom backwards, your game is upside down!

[Televator]

....and all the audio defaults to the E.T. 2600 soundtrack. In mono, of course.

[SEGAretro]

I've got the special Everdrive MD 2600 version... It's a little harder to get it working, because you have to set the switches manually for every game.



But back ontopic: there won't be any difference in gameplay/audio/graphics between the original cartridge or the Everdrive.

I love my Everdrive

[aka DaBigKahuna]

Thanks for the feedback and for those clowning me on the 2600 if I see you I am going to sock you in your throat .



Any rom site recommendations or is that taboo to discuss? I just bought one and the snes overdrive.

[aka DaBigKahuna]

Low enough to not have to file or just not sticking out as far?

Also is there any noticeable improvement in getting a higher speed card? Thx.

T-scene, I love the setup of your Genesis! Very clean! I picked up a v5 Model 1 for $2 at a flea market (it actually works fine) so I may give this a shot with it! That's one advantage of the later revision Model 1s...the EXT port would cause problems with an older one, I guess.

By the way, to address the ugly SD card sticking out, the low profile RS-MMC cards will work. This was brought up on assembler and Krikzz said they are supported.

http://www.amazon.com/eTECH-RSMMC-ME...1744296&sr=8-5

[NeoVamp]

if I see you I am going to sock you in your throat .

lol Internet threats.

[aka DaBigKahuna]

Nah, see the smiley face under.

lol Internet threats.

[turntablist1210]

Anyone seen this?

http://www.youtube.com/watch?v=v7G0i...layer_embedded

looks promising

[makinagenesis]

yea, its been out ages

this one will just have more features than the last