Weird colors after encoder reinstall

[t-scene]

I decided to put my VA3 Non-TMSS Genesis back together. I had stole some caps, video encoder and voltage regs. off it for another project.
After putting it all back together it works but I have a weird on screen colors.

What did I leave out or screw up?

IMG_20120415_003025.jpg

IMG_20120415_003104.jpg

[TmEE]

Red is gone. Check CXA input pins and their circuitry. Should be pin 2 or 4

[Chibisteven]

Red is gone. Check CXA input pins and their circuitry. Should be pin 2 or 4

Pretty much this.

[t-scene]

does anyone know what the resistor value is that goes between the pin and the board connection.
turns out the old one is cracked and not making a connection

[Guntz]

75ohm.

Sorry, should have replied here sooner.

[t-scene]

Alright thank you! That is for pin 2 3 4 right?

[Guntz]

Yes, each of the three RGB output lines have a 75ohm resistor.