Quantcast

Search:

Type: Posts; User: goombakid

Page 1 of 2 1 2

Search: Search took 0.06 seconds.

  1. Replies
    51
    Views
    18,621

    For me, I liked the music and how riveting the...

    For me, I liked the music and how riveting the story line was. It was one of the few RPG series that I actually was determined to finish, and I've played my fare share of RPGs
  2. Replies
    28
    Views
    10,482

    I usually take +5V from the 7805 voltage...

    I usually take +5V from the 7805 voltage regulator itself (rightmost leg). You can also try using a NTE85 instead of a 2N3904 as your luma transistor.
  3. Sticky: Sounds great! Looking forward to it. Thanks!

    Sounds great! Looking forward to it. Thanks!
  4. Sticky: Any way we can get the pictures back on the fist...

    Any way we can get the pictures back on the fist page? All of them 404'd and I like to use them as a guide when I'm looking at Genesis'.
  5. Replies
    21
    Views
    5,801

    Very nice. Can't wait to see the result.

    Very nice. Can't wait to see the result.
  6. Replies
    4
    Views
    782

    Grounds are usually common. You should be able to...

    Grounds are usually common. You should be able to take those 2 points and ground them to, say, pin 5 on the VGA and call it good.

    Also, you have Vsync hooked up too, right?
  7. If it's hand made, then they may have just taken...

    If it's hand made, then they may have just taken the mono out from the port and split it to the RCAs. Kinda like getting one of these:

    8951

    for the FL NES consoles.
  8. Replies
    21
    Views
    5,801

    Mmmonkey's circuit design is pretty much what...

    Mmmonkey's circuit design is pretty much what I've used. However, I got a PCB from another forum:
    http://www.neo-geo.com/forums/showthread.php?240701-IC-Dreamcast-VGA-board

    Uses the same...
  9. Replies
    21
    Views
    5,801

    Seconded. I've seen your SD car board(s),...

    Seconded. I've seen your SD car board(s), something similar for a VGA mod would be great. It'll make it easier to internal VGA mod a DC.
  10. Replies
    19
    Views
    3,584

    If you're planning on doing a few projects, a...

    If you're planning on doing a few projects, a standard 15W or 20W iron from RS works (I've been using the same 20W one for ages). Since I've been more into modding recently, I got this one:
    ...
  11. Replies
    15
    Views
    6,429

    Funny. My IC mod works just fine with the TED. I...

    Funny. My IC mod works just fine with the TED. I think some IC mods are underpowered, therefore causing glitching and read/write problems. Even with regular HuCards, some IC mods caused them to...
  12. Replies
    0
    Views
    639

    TG-16 Sound boost...

    So, I got bored wait for a response (on various forums) for boosting audio from the TG-16's EXP. I looked online for a simple amp, when this circuit came up (multiple times) in my search.

    Hack A...
  13. BuMpdate: So I swapped out the 220uF cap with a...

    BuMpdate: So I swapped out the 220uF cap with a 100uF cap and added a 2k potentiometer. After much adjusting, I couldn't get a stable image. I swapped out the 2k with a 330 ohm potentiometer. Got...
  14. Replies
    28
    Views
    17,481

    Audio from RF was decent. When I first did my A/V...

    Audio from RF was decent. When I first did my A/V (composite) mod (RF left in), I had soft audio from the EXP. I've never got the TurboBooster, so I didn't have a benchmark for audio from the EXP.
  15. Replies
    28
    Views
    17,481

    Audio through the EXP is quiet for me on my...

    Audio through the EXP is quiet for me on my TG-16. Might be leaky caps, but before I took out the RF box, audio was decent.
  16. Replies
    28
    Views
    17,481

    I did the same S-Video mod from PCEngineFX.com...

    I did the same S-Video mod from PCEngineFX.com since that was the easiest one that I've seen prior to this. Works fine for me.

    I'm in with Drakon about an audio amp. I've added 10 uF caps to the...
  17. Thanks. When I have time, I'm gonna swap out the...

    Thanks. When I have time, I'm gonna swap out the 220 uF cap with a 100uF cap and maybe change the resistor to a 1k variable resistor.
  18. http://img.photobucket.com/albums/v246/ryo808/IMAG...

    http://img.photobucket.com/albums/v246/ryo808/IMAG0154.jpg
    Connections. I used disconnects to make it easier getting under the hood for future mods or cleanup.
    ...
  19. Well, here's the vids I tried to shoot tonight....

    Well, here's the vids I tried to shoot tonight. Pardon the quality and outside link.


    http://smg.photobucket.com/albums/v246/ryo808/?action=view&current=VIDEO0009.mp4
    Color shifting on The New...
  20. Hey, Drakon. Going on your modified circuit, how...

    Hey, Drakon. Going on your modified circuit, how different is the transistor that you used compared to a 2n3904? I also noticed that you took out the Luma resistor. You think that might make a...
  21. I sidelined this project, so I have it stored...

    I sidelined this project, so I have it stored ATM. I'll try and bring it out tonight and get a video of what's happening.

    Like I said, I kept the cap on the Chroma line the same as recommended,...
  22. Well, I have no CRT's anymore. I'm not about to...

    Well, I have no CRT's anymore. I'm not about to go out and get a CRT TV just to play games.

    I did notice the first time around I did the install that I did get it backwards, so that was all...
  23. S-Video on a Model 1 Genesis; shifting colors...

    I did an S-Video mod on my Model 1 Genesis (VA2) using this tutorial:

    http://freezerdev.blogspot.com/2012/02/project-genesis-modding.html

    After some fiddling, I did get it to a point where...
  24. Replies
    6
    Views
    1,313

    It might have to do with the disc tray. I had...

    It might have to do with the disc tray. I had that problem before too.

    Try HERE to see if that might help. It's similar to what I ended up doing on mine.
  25. Replies
    10
    Views
    2,019

    For Trade PM sent.

    PM sent.
Results 1 to 25 of 36
Page 1 of 2 1 2